A video repost to show why I'm going to the trouble to change vise on the bench. I love wood screws, they hold well, tell you with a squawk when they are tight enough, and are pretty but they will not do this:
ken
Subscribe to:
Post Comments (Atom)
2026 Winter Grow
Four in the tent, six on standby in the Vseed. If none of the six are needed to replace one or more of the tent plants they will be transpla...
-
I'm going to ignore growing Cannabis outdoors in the Sun and build out grow rooms. This post is about setting up a "grow Tent"...
-
We made it! Truth is it wasn't that bad, MsBubba might disagree but it wasn't that bad. Are we booked to camp host on the Oregon co...
-
On the road to Houston for a month or till the kids piss me off, trips in a motor home are seldom without drama. The new to me 2002 40'...
That Bench Crafted stuff is very very nice...
ReplyDeleteBob, drooling 😁
Bob,
ReplyDeleteI'm not sure what happened today but I pulled the chop to trim the top and clean it up a little. Pulling the chop just involves pulling the top backer board pin and unscrewing the vise screw. What ever when I re-installed the screw and pin the whole vise was binding. Ended up pulling the whole vise module and doing a new install. Not a clue what happened or changed.
ken