A video repost to show why I'm going to the trouble to change vise on the bench. I love wood screws, they hold well, tell you with a squawk when they are tight enough, and are pretty but they will not do this:
ken
Subscribe to:
Post Comments (Atom)
MotorHomes
On the road to Houston for a month or till the kids piss me off, trips in a motor home are seldom without drama. The new to me 2002 40'...
-
Nova OG Auto planted Oct 8, 2022. Harvested Jan 4, 2023, week 13 seeds in ground. Ninety one days from seed popping to harvest. The other ... -
I'm going to ignore growing Cannabis outdoors in the Sun and build out grow rooms. This post is about setting up a "grow Tent"...
-
Moravian Bench with a Lake Erie Wood Screw vise: From the other end: The folks that built the original bench were very clever, Every joint ...
That Bench Crafted stuff is very very nice...
ReplyDeleteBob, drooling 😁
Bob,
ReplyDeleteI'm not sure what happened today but I pulled the chop to trim the top and clean it up a little. Pulling the chop just involves pulling the top backer board pin and unscrewing the vise screw. What ever when I re-installed the screw and pin the whole vise was binding. Ended up pulling the whole vise module and doing a new install. Not a clue what happened or changed.
ken