A video repost to show why I'm going to the trouble to change vise on the bench. I love wood screws, they hold well, tell you with a squawk when they are tight enough, and are pretty but they will not do this:
ken
Subscribe to:
Post Comments (Atom)
-
I'm going to ignore growing Cannabis outdoors in the Sun and build out grow rooms. This post is about setting up a "grow Tent"...
-
I'm growing one GG4 Auto in Coco Coir alongside the six I have growing in a DWC setup. The first observation is the Coco Coir grow is m... -
Moved the three smaller plants to the side of the tent. The tent is still tight to work in but much better. Remember click 'em to big ...
That Bench Crafted stuff is very very nice...
ReplyDeleteBob, drooling 😁
Bob,
ReplyDeleteI'm not sure what happened today but I pulled the chop to trim the top and clean it up a little. Pulling the chop just involves pulling the top backer board pin and unscrewing the vise screw. What ever when I re-installed the screw and pin the whole vise was binding. Ended up pulling the whole vise module and doing a new install. Not a clue what happened or changed.
ken